Chapter 2
Unpacking and Installing the Switch
2 - 10
Attach a console cable to the serial console to access the CLI (9600 baud,
8-N-1).
Connect an Ethernet cable (copper) to the OOB management port as
instructed in
Connecting the Switch to the Network, on page 3-1
, which
provides instructions and examples for the initial-boot process.
You can cable the client/server port any time after powering up the chassis.
You can also cable the redundancy link to its peer at any time. To join the
switches as a redundant pair, follow the instructions in the
ARX
®
CLI
Network-Management Guide
after the initial-boot process is finished.
Summary of Contents for ARX-500
