1000BaseCX full
10GBaseER full
1000BaseT half
10GBaseLR full
1000BaseT full
10GBaseSR full
1000BaseSX full
10GBaseT full
auto
10SFP+Cu full
none
40GBaseSR4 full
no-phy
40GBaseLR4 full
100BaseTX half
Viewing valid media types for an interface using tmsh
You can use
tmsh
to view the valid media types for an interface.
Note: This platform might not support all of the media type options that are available in
tmsh
.
1.
Open the Traffic Management Shell (tmsh).
tmsh
2.
Change to the network module.
net
The system prompt updates with the module name:
user@bigip01(Active)(/Common)(tmos.net)#
.
3.
Display the valid media types for a specific interface.
show running-config interface <interface_key> media-capabilities
Important: In all Gigabit Ethernet modes, the only valid duplex mode is full duplex.
The following is an example of the output you might see when you issue this command on interface
1.3:
net interface 1.3 {
media-capabilities {
none
auto
10T-FD
10T-HD
100TX-FD
100TX-HD
1000T-FD
1000T-HD
}
}
Network interface LED behavior
The appearance and behavior of the network interface LEDs on the platform indicate network traffic activity,
interface speed, and interface duplexity.
18
The 11050 Platform
Summary of Contents for BIG-IP 11050
