3.
Repeat steps 1 and 2 for the other bracket.
4.
Lift the unit into place in the rack.
Caution: Due to the weight of the chassis, this step requires two people.
5.
Secure the unit to the rack using four rack manufacturer-provided screws on each side.
The unit must be securely fastened to the rack to provide adequate stability and to prevent the unit from
falling out of the rack.
6.
Attach the front bezel to the unit by grasping the bezel on either side using the indentations provided.
Note: Failure to use the indentations could result in pinched fingers.
Installing to a 23-inch rack using a center-mounting kit
Before you install this platform, review the environmental guidelines to make sure that you are installing
and using the platform in the appropriate environment.
Caution: Due to the weight of this platform, two people are required to unpack and install it. Failing to
use two people can result in severe personal injury or equipment damage and might violate safety regulations.
35
Platform Guide: 11050
Summary of Contents for BIG-IP 11050
