NEBS platform guidelines
The following information applies to the Network Equipment-Building System (NEBS) version of the 11050
platform.
This equipment meets NEBS requirements per GR-63-CORE.
This equipment is suitable for installation in the following:
•
Network Telecommunication Facilities
•
Locations where the National Electrical Code (NEC) applies
Important: The intra-building interfaces of this platform, including Ethernet, are suitable for connection
to intra-building or unexposed wiring or cabling only with shielded and grounded cables at both ends. The
intra-building ports of the equipment must not be metallically connected to interfaces that connect to the
outside plant (OSP) or its wiring.
Note: You should coat bare conductors with an appropriate antioxidant compound before you make crimp
connections. You should bring all unplated connectors, braided strap, and bus bars to a bright finish and
then coat them with an antioxidant before you connect them.
Platform airflow diagram
The platform employs a negative pressure fan system, which draws cold air in from the front of the chassis
and exhausts hot air out the back of the chassis.
54
Environmental Guidelines
Summary of Contents for BIG-IP 11050
