© 2006 F5 Networks, Inc. All rights reserved. F5, F5 Networks, the F5 logo, WANJet, and iControl are trademarks or registered trademarks, and Ask F5 is a service mark, of F5 Networks, Inc. in the U.S. and in certain
other countries. This product protected by U.S. Patent 6,327,242. Other patents pending.
PUB-0155-01
F5 WANJet
™
400 Appliance
Quick Start Card
How to get started with the WANJet 400 appliance
WANJet 400 | Quick Start Card
F5 Networks, Inc. Technical Support
(888) 88ASKF5 Toll-free • +(800) 11ASK4F5 Intl • (206) 272-6802 Fax • support@f5.com (Support) • askf5@f5.com (AskF5
SM
)
6 Cable the WANJet 400 appliance
1
Connect the blue Ethernet CAT6 cable to the
LAN port on the front of the WANJet appliance.
Connect the other end to your LAN switch.
2
Connect the orange crossover CAT6 cable to the
WAN Port on the front of the WANJet appliance.
Connect the other end to your WAN router.
3
You may optionally connect an Ethernet cable to the Management port on the front of the WANJet appliance.
Connect the other end to your management network.
Plug the blue
Ethernet cable
into the LAN port
Plug the orange
crossover cable
into the WAN port
LAN WAN
Optional: Plug an Ethernet
cable into the Management
port (for out-of-band
management)
1
In a web browser, go to
https://<WANJet
IP address>:10000
. (If you set up the
Management port, use the
Mgt IP Address
instead.) The WANJet appliance login screen
opens.
2
Type the user name and password (the defaults
are both
admin
), and then click
Log On
. The
Web UI opens and displays the WANJet Status
screen.
1
In the WANJet Status screen, click the
Not
entered
link, next to
License
, to display the
WANJet License Details screen.
2
After
Base Registration Key
, you should see
your registration key (fi lled in at the factory).
3
Click
Next
.
The EULA (End User License Agreement)
screen opens.
4
Read the EULA, and then click
Accept
if
you agree to the conditions. When license
activation is complete, the WANJet License
Details screen opens and shows the current
license date.
Note:
If automatic license activation does not work,
you can use manual activation instead. On the
WANJet License Details screen, next to
Activation
Method
, select
Manual
and follow the directions on
the screen.
Next, you can complete the confi guration of the
WANJet appliance including changing the default
password, specifying remote WANJet appliances,
and setting up optimization, IT service, and QoS
policies. See the
WANJet Appliance Administrator
Guide
for details.
7 Log on to the WANJet 400 appliance
Finally, check that you can log on to the appliance remotely, and activate the license.
To log on
To activate the license
