Rev. 02-20
Page 5/9
Alu Shower chair with tilt 2024 – User manual
Toilet bucket
Put the lid on the bucket (see the first picture)
Slide it in to the rails located under the seat. You should do it from the back pushing towards
the front of the chair (see the second picture)
When the bucket is in its place cover the middle hole of the seat with the PU cover (see the
last picture)
Footrests
Now you can attach the footrests.
Put the footrests top end into the hole located at the top front end of the main frame. The
footrest should be directed outwards at that point.
Now turn the footrest in until it will lock in its front position.
Repeat the same procedure for the second footrest.
To unlock and detach the footrest press the locking lever, turn the footrest outwards and then
pull it up. The above function together with these elevating footplates help to transfer the user
into and out of the chair. It also helps to wash all the parts of the users’ body during the
shower when footrests are moved to the side or removed fully.
Never move the chair with the footrests detached when there is someone in it. Always put
users’ feet on foot plates when moving the chair.
Armrest
Armrests can be easily lifted by pulling them up. To move them back in to a low position
simply push them down. This function helps to transfer the user in and out of the chair and it
helps to bath the user.
Never leave chair unattended with armrests lifted when there is someone in it.
Tilt adjustment function
The chair is featured with a tilt adjustment function which allows you to
adjust the angle of the chair in a position from -5º to + 25º.
It can be activated by depressing the levers located in the rear top part of
the back.
After depressing the levers you can move the seat angle up or down.
Adjusting the angle of the seat increases the comfort of the user and helps
to wash and to move the user in or out of the chair.
Never leave a patient unattended in the chair with the seat tilted to the max
in either direction.
Transport recommendations
The shower chair is not a device designed for frequent transportation. If it is necessary to transport
the chair, we recommend to disassembly it in the opposite wat of the assembly description above.
The chair should be packed in a way where it is stable and there is no risk of sudden and dangerous
movements
of
the
transported
device.