390 / 390 24
ENGLISH
Guide for the installer
Page
3.3. INSTALLATION STEPS
The operator, base-plate and articulated arm are designed either
for right-hand or left-hand (Fig. 7) installation.
Secure the base-plate to the pilaster, using Ø10 screws and suita-
ble expansion plugs (Fig. 8), and check it is perfectly horizontal.
Fit the gearmotor unit on the base-plate and secure it with the
two screws, nuts and flexible washers (Fig.8).
The transmission shaft must always face downward.
Assemble the articulated arm and front coupling as shown in
Fig. 9.
Fit the straight lever of the articulated arm on the gearmotor shaft
and tighten it with the supplied screw and washer (Fig. 10).
Release the operator (chapter 4.)
Establish the securing position of the front coupling on the leaf,
observing dimension “
C
” defined previously (chapter 4.2). Check
that arm and coupling are perfectly horizontal.
The coupling may be welded directly onto the leaf (Fig. 11)
or screwed by using the threaded inserts (Fig. 12).
In both cases, mark the position of the front fitting and provisionally
remove the coupling from the arm in order to secure it.
After having fastened the front fitting, mount the arm again
Fit the guards on the operator (Fig. 10).
Re-lock the operator (chapter 5.)
Make the electrical connections of the selected electronic ap-
pliance, observing the annexed instructions.
3.4. TEST OF THE AUTOMATION
When you have finished installation, carefully check the operating
efficiency of the automation and of all accessories connected to
it, safety devices in particular.
Hand the “User’s Guide” page to the Client, and describe how
the operator should function and be used correctly, stressing the
potentially dangerous areas of the automation.
4. MANUAL OPERATING MODE
If the gate has to be operated manually in the event of a power-cut
or fault to the automation, use the release device as follows:
Cut power to the system.
Fit the supplied Allen wrench and turn it by about a half turn until
it stops, in the direction shown in Fig. 13, depending on type of
installation.
Move the gate by hand.
5. RESTORING NORMAL OPERATING MODE
To avoid an involuntary pulse from activating the gate during
the manoeuvre, before re-locking the operator , switch off
power to the system.
Fit the supplied Allen wrench and turn it by about a half turn until
it stops, in the direction shown in Fig. 13, depending on type of
installation.
make sure that the gate cannot be moved manually.
Restore power to the system.
6. MAINTENANCE
To ensure correct long-term operation and a constant level of
safety, we advise you to generally control the system at least
every 6 months. In the “
User’s Guide
” booklet, there is a form for
recording jobs.
7. REPAIRS
The User must not in any way attempt to repair or to take direct
action and must solely contact qualified FAAC personnel or
FAAC service centres.
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
