8
ENGLISH
fig. 16
POSITIONING THE FORK SUPPORT FOUNDATION PLATE
To position the foundation plate of the fork support, refer to
fig.16 where:
P1 = barrier foundation plate
P2 = fork support foundation plate
L = beam length (in mm)
A = L - 195 (in mm)
Whenever doing maintenance, always check correct
settings of the by-pass screws, system balancing, and
efficiency of safety devices. The automated system does
not require any type of oil topping-up.
fig. 17
fig. 14
SKIRT KIT (fig.14)
The skirt kit increases visibility of the beam.
It is available in lengths from 2 m to 3 m.
If a skirt kit is installed, the balancing spring must be
adapted.
FORK SUPPORT (fig.15)
The fork has two functions:
- it prevents the beam, when closed, from bending or splitting
if its end is stressed by extraneous forces.
- it allows the beam to rest when closed and thus prevents
the profile bending downward.
fig. 15
ARTICULATION KIT (fig.17)
The articulation kit makes it possible to articulate a rigid
beam to a maximum ceiling height of 3 m. (see specific
instructions).
Dimensions are in mm.
fig. 18
END FOOT (fig.18)
The end foot allows the beam to rest when closed and thus
prevents the profile bending downward.
For any repairs, contact FAAC’s authorised Repair Centres.
9 AVAILABLE ACCESSORIES
If the articulated kit is installed, the balancing
spring must be adapted.
If a foot is installed, the balancing spring must be
readjusted.
10 MAINTENANCE
11 REPAIRS
Summary of Contents for 615
Page 1: ...615 615...
