FAAC 950N, Manual

950N 16 

732708

 - Rev. F

950 MPS

ENGLISH

6  PROGRAMMING THE 950 MPS BOARD

DS1 950 MPS SETTING

N°

FUNCTION

OFF

ON

NOTE

1

Final closing stroke

Disabled

Enabled

In the closed door position, it al-

lows the door to be kept constantly 

pressurised via the motor. (do not 

enable if push and go is ON)

2

Set-up procedure

Articulated arm and/

or openings up 

to 90°

Sliding arm and/

or openings  

greater than 90°

3

External selector switch in 

position 2

Position 2 

set on 

Manual

Position 2 

set on 

Night

Allows to decide which mode is to 

be associated to position 2 of the 

external selector switch

4

Push and go

Disabled

Enabled

Set the outer selector switch to 

position 0 (automatic) and push 

or pull the door to open it. (do not 

enable if the final closing stroke is 

ON)

5

Leaf delay at opening

(master/slave application)

Disabled

Enabled

6

Special automatic function

(Not available in the master 

and slave application)

Disabled

Enabled

When in automatic mode, if this 

parameter is enabled, the motor 

will not prevent manual opening.

7

Not used

8

SCP 

(Selectable Close Powe-

ring)

Additional force before 

closing

NOTE: With dip switch 9 

set to OFF, this function is 

never active

Disabled

Enabled

When this function is enabled, it 

reduces the sensitivity of the

electronic anti-crushing device. 

The activation of this function is 

useful whenever high friction, 

particularly hard door gaskets or 

electric locks with difficult latching 

are present.

9

FAILSAFE

(safety devices test as per 

EN 16005)

LOW ENERGY

(low energy operation as 

required by EN 16005)

FAILSAFE TEST 

NOT ACTIVE

LOW ENERGY 

ACTIVE

FAILSAFE TEST 

ACTIVE

LOW ENERGY 

NOT ACTIVE

If set to the ON position, dip sw 

9 selects the activation of the 

opening/closing function test of the 

safety sensors.

If set to the OFF position, the 

sensor test is disabled and the 

movement of leaf can be set in the 

“Low energy” mode as required by 

Standard EN 16005. 

When dip switch 9 is ON, the “inter-

lock” function and the gong are no 

longer available.

10

Board updating using the 

RS232 port

Disabled

Enabled

Allows enabling of the RS232 

port for connection with the PC to 

perform firmware updates.

Fig.4