Estate Swing 433 Plug-in Receiver (cont.)
5. Plug the white clip inside the control box into the
control board. The groove in the white clip should
snap into the guide on the 5 prong connector. (
Fig
1
)
6. The red power light should come on the receiver.
(
Fig 2
)
7. Program your remotes to the receiver:
A.
Press and release the LEARN1 button at the top
of the receiver board (ex 1). The learn LED will
illuminate steady (ex 2). (
Fig 3
)
B.
Press and hold the button on the remote you
wish to program to the receiver.
C.
Hold the remote button until the Learn LED
flashes and then turns off. (caution your gate open-
er may be triggered during this process)
D.
Repeat A through C for all additional remotes.
Fig. 1
Fig. 2
Fig. 3
NOTES ABOUT REMOTES:
You can program up to 400 codes into the receiver. This could mean 1 button on 400 different remotes or
this could mean all 4 buttons on 100 remotes or anything in between. Some choose to program all 4 buttons
to a single receiver if they are not using multiple gates to eliminate pressing the incorrect button on the re-
mote. To do so follow the programming above with each button of the remote. You can erase all pro-
grammed codes by holding Learn 1 until the Learn LED comes ON and then turns OFF.
8. Put the cover on the receiver and secure it in place using the provided screw.
IMPORTANT:
The receiver is a drip proof receiver. This means that it is designed to
prevent water from accessing the inside of the receiver when the water is moving downward
with gravity (rain for example).
DO NOT
mount the r eceiver anyplace that water may access it from another angle.
For example: Do not mount near sprinklers. Do not mount the receiver horizontally. Do not
mount the receiver near a flat surface where water could splash upwards.
4.10
