4.1
Mounting the Control Board and Box
Position your control box on the post of the gate or a nearby fence.
(1)
Remove the rubber covers on the back of the box to reveal the holes. Use these holes to
mount the box, and then put the rubber covers over the screw heads to prevent water leakage.
*For a dual operator set-up, the control box will be on the same side of the driveway as the mas-
ter
control arm.
(2)
Use the knockouts in the bottom of the box to run your wires into the control box. The knock-
outs
are multi-sized - purchase water tight connectors to run the wires into the box. The water tight
connectors go in the knockouts on the bottom.
(3)
To mount the control board, first mount the control board stand in the center of the box.
(4)
Place the caps provided over the pegs that will be used to attach the control board.
All wires being run to the control board should also be run through water-tight connec-
tors. Connectors are available from most home stores or your Estate Swing dealer.
If using backup batteries, create holes on the side of the box large enough for your wa-
tertight connectors and run your wires in from the side to make room for the battery.
