32
When the alarm system is enabled, if an opening
detector is declared active (e.g.: open window…), the
control unit sounds several BEEPS, to signal the
PASSAGE OPEN fault, and will not carry out the order.
To make a forced enable possible of the alarm:
- press
again during the 10 seconds after the first
pressure.
This method is identical for the remote-controls.
OK
OK
OK
OK
+
-
C
INFO
OK
OK
+
-
C
INFO
+
-
OK
OK
+
-
C
INFO
INFO
OK
In 10 seconds maximum time
BeeP
BeeP
Alarm ON / Alarm OFF
Maintenance Program mode
2 secs.
Alarm memory-stored / In progress
System sabotage alarm
Discharged batteries
Peripheral units fault /
Telephone line fault
Passage open signal
Forced enable (with
passage open)
Consulting alarm events
OK
+
-
C
INFO
OK
C
INFO
OK
+
-
INFO
INFO
INFO
INFO
INFO
INFO
INFO
INFO
Type in the access code.
The problem sign
appears on the display, it
means that a given event has occurred
Press the
key to consult the events.
Press the
key successively to scroll through the
events and respective characteristics: type of sensor,
name, date and time….
At the end of consultation, the message DELETE will
be shown.
Press the
key to delete all the events.
INFO
INFO
INFO
INFO
INFO
INFO
Impor
Impor
tant:
tant:
If the fault remains in the system (for example:
discharged batteries or telephone line fault), the
sign will appear again.
Impor
Impor
tant:
tant:
The opening detector - disabled at time of forced
enable - will not trip the alarm in the event of an
intrusion. To make it active again, close the door or
window in the place where it is installed.
Enabling and disabling the alarm system
Use
