4
Operation of the alarm system
To facilitate identification, we advise you to assign an
identifier (name and number) to each device. These
names will be used to name the devices with the control
keypad.
Example: “BEDROOM - No. 2” to indicate the second
bedroom of a house.
If you do not wish to use a given number to name one
of the devices, select digit 0.
H4 Alarm control unit
In the event of intrusion, the detector informs the control
unit, which will enable its integrated siren and the
outdoor siren (if present).
The control unit sounds the alert, following an alarm, by
calling four pre-programmed telephone numbers. It
describes the type of alarm and enables the user to
listen to the noises in the room where it is installed. It
can be remotely enabled or disabled and also indicates
the system’s current status and the internal
temperature.
4-key remote-control
For totally activating and disabling the alarm system.
The remote-control (supplied) is programmed as
follows:
ON = push-button 4,
OFF = push-button 1.
Opening detector
It must be installed on a door or window. It detects any
opening, signalling it to the control unit.
Movement detector
It must be installed on a wall. It detects any person
moving inside the room where it is installed, signalling
this to the control unit.
The kit devices
ON = push-button 4
OFF = push-button 1
Alarm ON / Alarm OFF
Maintenance Program mode
2 secs.
Alarm memory-stored / In progress
System sabotage alarm
Discharged batteries
Peripheral units fault /
Telephone line fault
Passage open signal
Presentation
