X 2
X 1
X 3
X 2
ENGLISH
22
9.3.1 MODIFYING THE SENSITIVITY OF THE OBSTACLE DETECTION
1) Press the programming push-button 4 times
2) The motor performs three brief movements in both directions to confirm you have entered the advanced menu
3) Press N times the down push-button for 2 seconds to select the sensitivity level of the obstacle detection you wish to
obtain ( 1 pressing: obstacle detection disabled.....9 pressing: maximum obstacle detection ), and within one second
press and hold down the down push-button until the motor operates, to confirm.
4) The motor performs a brief movement in both directions to confirm the performed setting of the obstacle detection
sensitivity and the exit from the advanced menu.
5) If the motor performs three brief movements in both directions, this means that the procedure was not performed
correctly and that you are still in the advanced menu. Repeat point 3.
every pressing
2 seconds
5
seconds
The motor performs three brief
movements to confirm you have
entered the advanced menu
Press twice the STOP/PREFERRED POSITION push-button (every pressing
2 seconds) and within 1 second press the STOP/PREFERRED POSITION
push-button for 5 seconds to confirm the performed setting.
WITHIN 1 SECOND
The motor performs two brief movements in both directions to confirm the performed setting of the torque and the
exit from the advanced menu.
HIGH SENSITIVITY AREA
STANDARD SENSITIVITY AREA
9.2.1.2 DELETING ICE OR BOLTS DETECTION
1) Press the programming push-button four times
2) The motor performs three brief movements to confirm you have entered the advanced menu
3) Press the STOP/PREFERRED POSITION push-button once, press it again and hold it down until the motor performs 2
brief movements in both directions to confirm the ice and bolts detection has been deleted and the exit from the
advanced menu.
4) If the motor performs three brief movements in both directions, this means that the procedure was not performed
correctly and that you are still in the advanced menu. Repeat point 3.
9.3 FUNCTIONS LINKED TO THE OBSTACLE DETECTION
The obstacle detection in the last centimetres before the travel limit is “inhibited”. If you wish to activate this function also
for that area, observe the operations described in chapter 9.3.2