a
c
a
A = ..x.. mm
A = ..x.. mm
Ø 3 mm
b
b
4X10
a
c
b
a
b
ENGLISH
4
Fig. 2
Fig. 3
Fig. 4
Fig. 5
3 INSTALLATION
3.1 ASSEMBLING THE TUBULAR MOTOR
1) Fit the crown adapter (Fig.2 ref.
a
) in the tubular motor,
until it is completely inserted in the guide on the travel
limit ring nut.
2) Fit the wheel adapter (Fig.2 ref.
b
) in the motor shaft. 3)
Lock the adapter with the supplied stop. (Fig.2 ref.
c
)
4) Make sure that the adapter is well secured (Fig.2 ref.
c
)
3.2 INSTALLING THE TUBULAR MOTOR
1) Measure dimension A on the tubular motor, as shown
in figure 3 ref.
a
.
2) Drill a hole with a drill Ø 3 mm on the roller (Fig.3 ref.
b
) at the distance A, previously measured on the tubular
motor (Fig.3 ref.
a
).
3) Fit the assembled tubular motor inside the roller from
the side opposite the cap, until the crown adapter is
completely inside the roller (Fig.4 ref.
a
).
4) Secure the wheel adapter to the roller with a tapping
screw 4x10 fitted in the previously drilled hole, as shown
in figure 4 ref.
b
.
5) Install the previously chosen motor support from the side
of the electric facility (Fig 5 ref
a
).
6) Fit the motor-driven roller in the motor support (Fig.5 ref.
b
), and on the cap support (Fig.5 ref.
c
).
7) Check with a level if the motor-driven roller is perfectly
horizontal; if necessary, modify the height of the motor or
cap supports.
ELECTRIC FACILITY SIDE
Summary of Contents for T-MODE TM 45 R 15/17
Page 1: ...T MODE TM R W 433 Mhz ...
