XKPR / XTRR
15
532267 - Rev.B
MAINTENANCE
Clean the outer surfaces only with a soft cloth Do not use detergents or oils. Do not make any modifications
to the original components. Only use original FAAC spare parts.
4. CONNECTING TO THE BOARD WITH SPINET
-
Connect the Spinet Bus to terminal J1 as indicated in
2 .
!
For each device connected to the SPINet line, position the address Pins so that the same address
is used on only one device.
5. TROUBLESHOOTING
Indication
Explanation
Necessary action
The XKPR/XTRR gives an error
when it is switched on.
There are two readers with the
same address.
Change the address for one of the
two devices.
No LEDs (Red or Green) are activa-
ted when a code is entered.
The keypad is disabled.
Check the keypad configuration of
the Device in the Keydom software.
The device does not turn on.
No power or device not working. Check that the power supply is
connected and live. If there are no
errors, replace the device.
An enabled user code or the tran-
sponder has not been validated,
the red LED lights up.
Software configuration error.
Check the Access Media configura-
tion in Keydom.
After installation, the reader XKPR/
XTRR1356 does not read the card
External cover installed incor-
rectly
Make sure that the parts of the
cover, separated by the cut, do not
touch each other after the screws
have been tightened. See
7
EN
Translation of the original instructions
XKPR
: To type in a code, enter the numbers that make up the code in sequence, pressing one key at time.
When finished press key
E
.
Pressing the
#
key will cancel the last digit that was entered.
LL
The operation of the Buzzer and the Backlight is configurable via the SW Keydom.
