Version Hi-Lo 02/04 - Page 6
PREPARE THE WALL
1.
Disconnect and move freestanding range from cabi-
net opening to provide easier access to upper cabinet and
rear wall. Put a thick, protective covering over cooktop,
set-in range or countertop to protect from damage or dirt.
2.
Determine and clearly mark with a pencil the center
line on the cabinet where the rangehood will be installed.
3.
Determine and make all necessary cuts in the wall for
the ductwork. Install the ductwork before the rangehood.
4.
Determine the proper location for the Power Supply
Cable. Use a 1 1/4" Drill Bit to make this hole. Install the
cable. Use caulking to seal around the hole. DO NOT turn
on the power until installation is complete.
5.
Make the cut-out opening where the rangehood will be
installed (FIGURE 5).
INSTALL THE RANGEHOOD
1.
Remove the rangehood from the carton and place on a flat
surface. Cover the surface to prevent accidental damage.
Remove all parts including the backdraft damper, plastic grille
and literature package before discarding the carton.
2.
Remove the grease filters from the rangehood and set
aside. The grease filters are removed by pressing the handle
of the filter as indicated in FIGURE 6. When replacing, make
sure that the filters are properly positioned with the handles in
front and visible.
FIGURE 5
CUT-OUT
27
5/8"
13
5/32"
FIGURE 6
3.
Place the round damper into the exhaust opening of the
rangehood and press down.
4.
The rangehood mounts to the cabinet by two spring
loaded brackets, one on each side of the rangehood. Lift the
rangehood into the cutout opening in the cabinet. Be careful not
to damage the cabinet, rangehood or other appliances.
5.
Tighten the rangehood to the cabinet by rotating the
screws indicated in FIGURE 7 with a phillips screw driver.
FIGURE 7
6.
Remove the cover from the field wiring compartment with
a phillips screwdriver. Feed the Power Supply Cable through
the electrical knockout. Connect the Power Supply Cable to the
rangehood cable. Attach the White lead of the power supply to
the White lead of the rangehood with a twist-on type wire
connector. Attach the Black lead of the power supply to the
Black lead of the rangehood with a twist-on type wire connector.
Attach the Power Supply Cable grounding lead to the green screw
provided. Using the 4 holes provided screw the field wiring
compartment to the wall or cabinet as dictated by your Power
Supply Cable location (screws not provided). Replace the
cover.
7.
Replace the grease filters.
8.
Connect the ductwork to the damper and seal all connec-
tions with duct tape.
9.
Turn the power supply on. Turn on the blower and light.
If the rangehood does not operate, check that the circuit breaker
is not tripped or the house fuse blown. If the unit still does not
operate, disconnect the power supply and check that the wiring
connections have been made properly.
