35
RECIRCULATION INSTRUCTIONS -
ONLY FOR BREVA30 AND BREVA36
For recirculating installations, Charcoal Filters are necessary. Remove all grease
filters and set aside. Attach one charcoal filter to each end of the Motor. Each
charcoal filter attaches to the grid on the side of the Motor. Rotate the filter
clockwise to install and counterclockwise to remove (FIGURE 3C). Replace all
grease filters.
There are 2 ways to recirculate the hood:
1) Use the Ductless Recirculating Kit
(sold separately)
, refer to installation in-
structions inside the Recirculating Kit which includes charcoal filters.
#
DUCTGRT304 or
#
DUCTGRT364
2) Duct work must be installed to exhaust the rangehood back into the kitchen,
either at the top of the cabinet (FIGURE 3A) or at the face or side of the soffit
(FIGURE 3B). Install at least 15" of metal duct (fig.3A and 3B) at the air exit. Run
the duct vertically and secure it at the opening cut out at the top or side of the
cabinet or soffit. Installation of metal grill is recommended. This duct work must
not terminate into a dead air space. #
FILTER6
must be purchased to complete
this type of installation.
Note: It is recommended that
professional style cooking always
be vented to the outside; for
recirculating Installations, some
duct work is required to exhaust
the unit out of the cabinet.
Summary of Contents for BREV368SS600
