User manual MatriX I.T.C. Honeywell
10 <
<
<
<
Device information and service
The device information, which is visible in the
display (see section 6.1), is required at a service
request.
The list includes the:
official name of the fire;
article number;
serial number;
date of installation;
load of the fire in kW.
Customising glow effect
Go to Menu > Settings > Flame image > Ashbed
flame following and select "Automatic” ON.
Auto on/off
The glow effect switches on at the moment that
there are flames. If you do not like this, this
function can be switched off. During use you can
temporarily switch on or off the glow effect with
the remote control or App.
Customising brightness glow effect
Select “Glow Effect” on the Home screen, fig. 2.0.
Click on the “flame” in the circle, fig. 2.1;
Click on the “settings” in the circle, fig. 2.2
With the three sliders you can set the base of the
glow effect, see fig. 2.3.
1. Velocity of fluctuating of the glow effect;
2. Glow effect of the wooden logs;
3. Glow effect of the ash bed.
Your selection will be saved when you exit the
setting screen.
This setting can also be customised when the fire is
enabled!
Setting of thermostat
For a proper functioning of the thermostat, it is
necessary that the remote control is installed in
the cradle in the prescribed location.
(See chapter 8).
Namely, room temperature is measured by the
remote control.
Manual setting of thermostat
The manual thermostat function is ON by default.
If the function is not used on a regular basis and if
the remote control is used for operation of the fire
instead of the App, we recommend to switch this
feature OFF. Unnecessary or unexpected enabling
will be avoided.
Setting of clock thermostat
The latter is switched OFF by default and can be
switched ON only if the manual mode is switched
ON.
Setting of clock program
The clock thermostat has a day and week feature.
When enabled, the fire follows the entered
program fully automatically until the fire is
switched off. With this setting you can customise
the program to your own needs.
The program has the following steps:
Getting up;
Leaving;
Coming home;
Sleep.
At each step the time and temperature can be set.
Please note!
The times do have to be connected to the
previous step.
Setting energy saving
Max room temperature
Here you can set the maximum room temperature
(default 31 degrees). If the temperature exceeds
the pre-set value, the fire will switch off.
This feature is provided to disable the fire if you
forgot to switch off the fire in manual mode when
leaving the room. Please note that if the remote
control is heated up by the sun or is located near
the fire, the temperature may quickly rise above 30
degrees.
Switch-off time in hours
If the fire is enabled in the manual mode or on one
of the Mood settings and during the pre-set time
no command is received from the remote control
or App, the I.T.C. will switch off the fire.
As a user, you can set this time between 1 and 24
hours.
Open-window detection
This feature is OFF by default.
By ENABLING this feature the open-window
detection is activated. If the I.T.C. detects an
unexpected rapid temperature drop within a pre-
set time this will be regarded as an open window
or door and the device will be disabled.
Display (setting display temperature
and consumption)
Sets how the temperature and consumption are
displayed.
At "Consumption" you can choose from:
Volume of gas in m³;
Energy consumption in kWh.
At "Temperature" you can choose from:
Celsius;
Fahrenheit.
