Faber FRIGOR 719, Instruction Manual

Remove all packaging material before 
using the new refrigerator. This 
includes the foam base and all 
adhesive tape holding the refrigerator 
accessories inside and outside.

Clean both the inside and outside of 
the refrigerator with wet cloth (a little 
detergent could be added into the 
warm water to wash the cloth and 
then wipe it again with the clean 
water);

Prepare an independent two-pole 
socket with grounding contact for the 
refrigerator and it shall not share a 
multi-purpose socket with other 
electrical appliances;

Do connect grounding wire! The 
grounding pole of the socket shall be 
provided with a reliable grounding 
wire.

Open the refrigerator body and take 
out the accessory (decorative cover 
for bottom beam) and the three 
screws from the instruction 
packaging bag; then install them into 
the bottom beam as shown by the 
schematic diagram on the right.

The decorative cover for bottom 
beam is used as ornament, so you 
can choose not to install it. It won't 
affect the refrigerator's performance 
or conditions no matter whether you 
install it or not.

Installation

Transport and Placing of Your 
Refrigerator

Transport

Keep upright and avoid squeezing or 
vibration during transport. Avoid a 
slant angle over 45 degree during 
handling.

Avoid the door or top cap from being 
under excessive stress when moving; 
otherwise, it may become deformed.

Placing

Place your refrigerator in a well-
ventilated place and keep it from heat 
source and direct sunlight. Don't 
place it in any humid or wet place so 
as to avoid rust and weakening of 
insulation effect.

There shall be a space not less than 
30cm from the top of your refrigerator 
and not less than 10cm from both 
sides or the back of the refrigerator to 
the adjacent walls respectively. This 
requirement is good for open and 
close of the door and also for heat 
emission.

The refrigerator shall be placed on a 
flat and firm ground (if not flat, you 
can use the leveling legs for 
adjustment).

Keep Your Refrigerator Standing

Don't connect your refrigerator to the 
power supply immediately after it is 
placed vertically. You should keep it 
standing for at least 6 hours before 
switching it on in order to ensure it 
running well.

Make sure the power wire is not 
pinned by the refrigerator or other 
objects so as to avoid accidents 
arising from power wire faults. Please 
check the voltage scope of your 
refrigerator against the actual power 
supply before switching it on.

07

08

Attention

The refrigerator must be disconnected 
from the source of electrical supply 
before attempting the installation of 
accessory.

Don't use mechanical equipment or 
other methods to accelerate the 
defrosting process except the means 
recommended by the manufacturer.

Don't use any electrical appliances in 
the food storage compartments except 
the model recommended by the 
manufacture.

The R134a refrigerant and cyclopentane 
foaming material used in the refrigerator 
are inflammable. All waste and 
discarded refrigerators shall be placed 
away from naked fire and they are not 
allowed to burn.

Screws

Decorative cover for bottom beam