Faber Respect OC, Installation Manual

10 < 

<

<

<

L   

 
For the Respect count measured value

 of 1.5 

% 

Co2 in the fresh air, this will not have a bad 

effect for the working of the appliance.   

8

Instructing the client 



Recommend that the appliance be 
serviced annually by a competent 

person in order to guarantee a safe 
use and a long lifespan. 



Advise and instruct the client about 
maintenance and cleaning of the 

glass. Emphasize the risk of burning in 
fingerprints. 



Instruct the client about the 

operation of the appliance and the 
remote control unit, including the 

replacement of the batteries and 
adjusting the receiver for initial use. 



Hand over to the client: 



 Installation manual  



 User’s manual 



 Imitation logs instruction card  



 Suction lifters   

9

Annual maintenance 

9.1

Service and cleaning:  



Check and clean if necessary after 
checking: 

o

The pilot light 

o

The burner  

o

The combustion chamber 

o

The glass 

o

The logs for possible fractures 

o

The outlet 

9.2

Replace: 

o

If necessary the 

chips/embers.  

o

in an LPG flat burner replace 
the burner sheet 

9.3

Cleaning the glass 

Most of the deposits can be removed with a 

dry cloth. You can use ceramic hob cleaner to 
clean the glass. 

Note: prevent fingerprints on the glass. these 
will be burned into it once the appliance is 

used and cannot be removed anymore! 
 

Carry-out the check-up according to the 
instructions in  (chapter 7) “checking the 

installation”. 
 

10

 Conversion to a different type of 
gas (e.g. propane) 

This can only be done by installing the proper 
burner unit. for this purpose get in touch with 

your supplier. 
Always mention the type and serial number of 

the appliance when ordering.