Faber TIMRA, Installation Manual And User Manual

UK/IRL

UK/IRL 23

5.3 Installation remote control (continuing)

Setting the right transmission code

The receiver has to learn the code from the transmitter, which is already set at the

factory. However the code disappears if the receiver is disconnected from the mains

for a longer period.

1. Push the "mod" button on the receiver and hold it for 3 seconds.

2. The green control lamp will light up and stay on. Repeat this step if not.

3. Push a button on the remote control. The control lamp on the receiver should now

go out.

4. Again push a button on the remote control. The lamp starts flashing and will switch

off eventually.

5.  The receiver now recognizes the remote control. The remote control now functions.

6.  Check if you can hear a sound and the motor runs when you push a button on the

remote control.

UK/IRL

UK/IRL 24

6. COMMISSIONING 

(functional checks)

6.1. Check pilot ignition

1. Push in and turn the control knob (A) anticlockwise to the setting 

 (small flame).

You will hear a tick meaning there is ignition. Hold the knob in and wait for a few

seconds while the air is purged.

2. Bring the knob back in the start position and turn the knob several times to the 

position. Check that the pilot has lit.

3. Continue to hold in the control knob for a further ten seconds to ensure that the

pilot flame is stable.

4. Release the knob. The pilot should remain alight.

6.2 Functional burner check

1. Turn knob (B) to max. clockwise.

2. Turn the knob (A) more anticlockwise to the position 

 (large flame). Now it is

possible to light the main burner.

3. Turn knob B anticlockwise to max. The main burner should light.