Faber TIMRA, Installation Manual And User Manual

UK/IRL

UK/IRL 29

8.1.1 Cleaning the glass

Depending on the intensity of use, you can get a deposit on the glass. This can be

removed with a special non abrasive ceramic glass cleaner (ceramic cook-top cleaner)

as follows:

1.  Remove the glass frame as described at 4.2.

2.  Clean the glass. Handle the glass with clean hands, wear gloves if possible.

3.  To fit the glass, proceed in reverse order. Make sure that the log set has been

installed correctly before fixing the glass.

Attention:

Before placing the glass: check the glass sealing rope is in good condition. Be sure

that there are no fingerprints on the glass. It is not possible to remove those prints

after you burn the appliance for a while (they are burnt in).

8.1.2 Cleaning the combustion chamber and burner

You can clean the combustion chamber with a vacuum cleaner.

8.1.3 Propane conversion

For coversion from natural gas to propane, order for a propane burner unit

Please give the serial number from the data badge when you order

UK/IRL

UK/IRL 30

8.1.3 Burner tray assembly log burner

1.  Remove the glass frame, trim, log set and burner tray cover.

2.  Break the gas supply at the control valve.

3.  Unscrew the burner assembly and take them out of the combustion chamber.

A. Pilot assembly

B. Burner

C. Fixation plate

D. Injector

E. Gas control

F. Receiver

8.1.4 Pilot/thermocouple assembly

Remove the burner tray as described above.

Now you have access to all the pilot and thermocouple parts

.