INSTRUCTIONS F330
9
Figure 18
Figure 22
Figure 20
Figure 19
3.3.2 Installation of The Gear Motors
1. Choose the correct dimensions of the motors and position to be installed.
2. Check if the mounting surface the brackets to be installed is smooth, vertical and rigid.
3. Arrange the cable conduit for power supply cable of the motors.
4. In order to obtain the optimal supporting from the rear plate, please assemble two post brackets and one rear metal
plate according to
Figure 18
.
5. Loosen the two screws and remove the back cover of the motor as shown in
Figure 19
.
6. Place the leaves in the closed position.
Figure 23
Figure 24
10. Refer to
Figure 23
, the distance between front plate of the motor and rear plate is 798mm (F330), the difference
in height is 2.5mm (F330).
11. Clamp and fix the motor front plate on the door temporarily.
7. Refer to the distance of “B” in
Figure 17
, place the rear plate in the correct position on the mounting surface.
Inspect if the distance is proper as shown in
Figure 23
i.e. the position the front plate of the motor to be installed.
8. Place two post brackets on the surface to be installed and mark the drilling points, then drill minimum diameter
of 8mm holes by four on the mounting surface to be installed and fasten up the brackets with screws and washers.
9. Please make sure the front plate is completely installed horizontally.
139
43mm
798mm
22.5mm
Figure 21
Summary of Contents for F330
Page 2: ......
Page 19: ...INSTRUCTIONS F330 17 Transformer Figure 3 3 8 5 12V 12V 12V ...
Page 28: ......
