Fabet F330, User Manual

INSTRUCTIONS F330

22

For four channel transmitter, there are four normal adjustments:

Situation 1: 

ASk:

 Transmitter button A for single leaf operation.

DkB:

 Transmitter button B for double leaves operation.

Situation 2: 

BSk:

 Transmitter button B for single leaf operation.

DkA:

 Transmitter button A for double leaves operation.

Situation 3: 

CSk:

 Transmitter button C for single leaf operation.

DkD:

 Transmitter button D for double leaves operation.

Situation 4: 

DSk:

 Transmitter button D for single leaf operation.

DkC:

 Transmitter button C for double leaves operation.

A

C

D

B

PR-2

D

k

S

k

A

B

D

k

S

k

C

D

D

k

S

k

A

B

D

k

S

k

C

D

See the following description:

D

k

D

k

S

k

S

k

A

C

B

D

Overheated Back-up Batteries

The gate doesn’t move when pressing the 

button of the transmitter

The gate only moves a little distance when

pressing the button of the transmitter.

The transmitting distance is too short

The gear motors run very slowly

The Flashing light does not work

The leaves shall be closed instead of opening

The leaves suddenly stop during moving

The leaves does not move or only move toward

one direction

The master gate closes to the end first and the

slave gate stops, the flashing light blinks fast for

five seconds.

The gear motors does not run and the relay is

noisy when operating the gate opening and

closing

Check the wiring connection of the batteries.

1. Check if LED3 or 4 is “ON”.

2. Check if the voltage of the batteries is below 22V.

3. Check if LED1 is “ON”.

4. Make sure all the wiring connections are firmly connected to the  

    terminals on the PCB.

5. Make sure the fuse is workable.

Make sure the wiring connection of the hall sensor is firm.

Make sure the connecting terminals of the

Antenna is firm.

Check the dip switch setting of the speed adjustment.

Check if the wiring connection of the flashing light is correct.

Change the polarity connection of the positive (+) with the negative (-) 

of the gear motors.

1. Check if the “RESET” socket is activated.

2. Make sure the wiring connection of the gear motors is firm.

3. Make sure the hall sensor wiring connection is firm.

4. The GND terminal of the photocells on the PCB must be 

    short-circuited if no photocells installed.

5. Make sure the fuse is workable.

1. Check if the “RESET” socket is activated.

2. Make sure the wiring connection of the gear motors is firm.

3. Make sure the hall sensor wiring connection is firm.

4. The GND terminal of the photocells on the PCB must be  

    short-circuited if no photocells installed.

Cut off the AC input power and the output of the batteries. Release the 

master gate and slave gate manually, then open the master to the end 

and close the slave gate to the end by hand, then power the whole unit 

by connecting the AC and battery terminals. 

Check if the fuse is burned.

5. Trouble Shooting