FabiaTech Corporation
39
Watchdog Timer Enabled
To enable the watchdog timer, you have to output a byte of timer factor to the
watchdog. The following is a Turbo C
++
program, which demonstrates how to
enable the watchdog timer and set the time-out period at 6 seconds.
#include “stdio.H”
#include “WDLIB.H”
main( )
{
char WD_TIME=ox6;
InitWD(equWdUnitS);
printf (“Enable watchdog”);
//Trigger watchdog Timer Output is 6 seconds
EnWD(WD_TIME);
}
Watchdog Timer Trigger
After you enable the watchdog timer, your program must write the same factor as
enabling to the watchdog register at least once every time-out period to its
previous setting. You can change the time-out period by writing another timer
factor to the watchdog register at any time, and you must trigger the watchdog
before the new time-out period in the next trigger. Below is a Turbo C
++
program,
which demonstrates how to trigger the watchdog timer:
#include “stdio.H”
#include “WDLIB.H”
main( )
{
char WD_TIME=ox6;
InitWD(equWdUnitS);
printf (“Enable watchdog”);
//Trigger watchdog Timer Output is 6 seconds
EnWD(WD_TIME);
}
Summary of Contents for Fanless Series FX5403
