11.
Click the “Load File” button in the Fablicator Inter-
face, select the G-Code file that was just created, and click
Open.
In this example it is
Ruler 6in.gcode
12.
Before starting the print, always apply a thin coat of
the primer solution to the print surface. Using a paper
towel, apply 1-3 squirts and wipe the bed in a circular mo-
tion to achieve an even coat.
The bed should still be damp when you finish wiping, and
it will air dry within a few seconds.
14.
When the bed reaches the target temperature, the
print will begin.
Once the print has finished, the extruder and bed will
turn off automatically.
13.
Once the bed is primed and G-Code file loaded, press
the
button
The Fablicator will automatically home all axis, and move
the extruder to a corner of the bed. The printer will also
automatically heat up the bed and extruder to the materi-
al settings from KISSlicer.
15.
When the print is complete, wait at least 5 minutes
for the bed to cool down before removing the part with
the safety razor.
If you do not wait for the part to cool
down, it may deform when you try and remove it, or be
extremely difficult to remove.
Printing a test part
