32. Locate the Alignment cam kit (FT292). Locate the
factory control arms. Install the lower control arms into
the Fabtech crossmembers using the hardware in the
cam kit (FT292). Torque the cam bolts at 200 ft-lbs after
alignment. Torque crossmember bolts to 240 ft-lbs.
SEE
FIGURE 33
33. If installing Dirt Logic coilovers (FTS221841) do so at
this time, using the instructions provided in the shock
box. Once finished, you may skip to STEP 39.
If using the factory coilover continue to STEP 34.
34. Locate the FT30558BK (Driver) and FT30605BK (Pass)
shock spacers.
35. Locate the factory coilovers. Using a press, press the
factory studs out of the bar pins.
SEE FIGURE 34
36. Install the Driver side spacer on the driver side coilover
using the factory hardware and torque to 35 ft-lbs. Repeat
on the passenger side.
SEE FIGURE 38
37. Install the coil over into the frame bucket using the
supplied 7/16” hardware. Torque 59 ft-lbs.
SEE FIGURE
36
38. Rotate the lower control arm up and mount to the lower
coilover bar pin using the supplied 1/2” hardware.
NOTE:
Install the lower bar pin spacers under the bar pin
(FT30604). Torque to 127 ft-lbs.
SEE FIGURE 37
10 of 16
FIGURE 33 - STEP 32
FIGURE 34 - STEP 35
FIGURE 35 - STEP 39
FIGURE 36 - STEP 42
FIGURE 37 - STEP 38
