39. Locate the factory knuckle and remove the 4WD actuator
and hub assembly.
SEE FIGURES 38-39 NOTE: REFER
TO FIGURE 65 ON THE LAST PAGE FOR SPECIFIC
INSTRUCTIONS ON DISASSEMBLY AND ASSEMBLY
OF THE 4WD ACTUATOR.
40. Locate the Fabtech driver side spindle (FT30601D) or
(FT30600D) and install the factory hub. Torque the four
14mm bolts to 160 ft- lbs.
SEE FIGURE 40
41. Re-install the 4WD actuator using the 3 factory bolts.
Torque to 29 ft-lbs.
SEE FIGURE 41
42. Install the Fabtech knuckle onto the upper and lower
control arms.
Torque the upper ball joint to 85 ft-lbs and
the lower ball joint to 110 ft-lbs.
SEE FIGURE 42-43
11 of 16
FIGURE 38 - STEP 39
FIGURE 39 - STEP 39
FIGURE 40 - STEP 40
FIGURE 42 - STEP 42
FIGURE 41 - STEP 41
FIGURE 43 - STEP 42
