2 of 9
For technical assistance call:
909-597-7800
or e-mail:
info@fabtechmotorsports.com
READ THIS BEFORE YOU BEGIN INSTALLATION -
Check all parts to the parts list above before beginning installation. If any parts are missing contact Fabtech at 909-597-7800
and a replacement part will be sent to you immediately.
Read all instructions thoroughly from start to finish before beginning the installation. If these instructions are not properly
followed severe frame, driveline and / or suspension damage may occur.
Check your local city and state laws prior to the installation of this system for legality. Do not install if not legal in your area.
Prior to the installation of this suspension system perform a front end alignment and record. Do not install this system if the
vehicle alignment is not within factory specifications. Check for frame and suspension damage prior to installation.
The installation of this suspension system should be performed by two professional mechanics.
This suspension must be installed with Fabtech shock absorbers.
Use the provided thread locking compound on all hardware.
WARNING- Installation of this system will alter the center of gravity of the vehicle and may increase roll over as compared
to stock.
Vehicles that receive oversized tires should check ball joints, uniballs, tie rods ends, pitman arm and idler arm every 2500-
5000 miles for wear and replace as needed.
Verify differential fluid is at manufactures recommended level prior to kit installation. Installation of the kit will reposition the
differential and the fill plug hole may be in a different position. (For example, if the manufacture recommends 3 quarts of fluid,
make sure the diff has 3 quarts of fluid). Check your specific manual for correct amount of fluid.
Footnotes-
- Some models may not sit level after install
- Will not fit 2019 models equipped with Magnetic Ride Control or Adaptive Ride Control
- Check with aftermarket wheel manufacturer for wheel compatibility on 2019 vehicle.
- PRE-INSTALLATION NOTES -
Required Tools (Not Included)
- Basic Hand Tools
- Floor Jack
- Jack Stands
- Assorted Metric and S.A.E sockets, and Allen wrenches
- TOOL LIST -
- Torque Wrench
- Die Grinder w/ Cutoff Wheel or Sawzall
- Hammer
- Coil Spring Compressor (2019 only)
- 36mm socket (2019 only)
Recommended Tire Sizes-
- Use 285/70R17 tires w/17x9 wheels w/5.5” BS w/ minor trimming
- Use 295/65R18 tires w/18x9 wheels w/5.5” BS w/ minor trimming
- Use 305/55R20 tires w/20x9 wheels w/5.5” BS w/ minor trimming
- Use 305/45R22 tires w/22x9 wheels w/5.5” BS w/ minor trimming
