3 of 9
(2007-2018 YEAR MODELS)
IF INSTALLING ON 2019 MODELS SKIP TO PAGE 5
1. Disconnect the negative terminal on the battery. Jack up
the front end of the truck and support the frame rails with
jack stands.
NEVER WORK UNDER AN UNSUPPORTED
VEHICLE!
Remove the front tires.
2. Working from the driver side, support the bottom of the
A-arm with a jack. If vehicle is equipped with autoride
disconnect the plug on top of the coilover assembly.
Remove the autoride bracket (if equipped from the A-arm
and save hardware.
SEE FIGURES 1-2
3. Loosen the upper ball joint nut, strike the knuckle with a
hammer till it comes loose from A-Arm. Save all hardware.
(Use care not to hit threads.)
SEE FIGURE 3
FIGURE 1 - STEP 2
FIGURE 2 - STEP 2
4. Loosen the tie rod nut and strike knuckle with hammer
till it comes loose. Save all hardware (Use care not to hit
threads.) Disconnect the factory swaybar endlinks and
save with the hardware.
SEE FIGURE 4
5. Remove the bottom coilover bolts and save. Disconnect
the ABS line retainer from the stud on the coilover and
remove the three nuts attaching the coilover to the
coilover mount, discard hardware. Remove the coilover
from vehicle.
SEE FIGURE 5
FIGURE 3 - STEP 3
FIGURE 4 - STEP 4
FIGURE 5 - STEP 5
