6 of 9
4. Using a 36mm socket, remove and save the axle hub nut.
SEE FIGURE 6
5. Remove and save the sway bar link nut from the bottom
side of the lower control arm.
SEE FIGURE 7
6. Loosen the upper ball joint nut and strike the knuckle with
a hammer until it comes loose from the upper control arm.
Next, remove and save the factory nut. Then detach the
knuckle from the upper control arm. Push the knuckle to
the side and secure if possible.
SEE FIGURE 8
FIGURE 7 - STEP 5
FIGURE 8 - STEP 6
7. Locate the plastic wire harness channel on the top of
the passenger side coilover mount. Push it up and back
to allow access to the three coilover nuts. Remove and
discard the upper coilover nuts.
SEE FIGURES 9-10
8. Remove and save the two lower coilover bolts. Then
remove the coilover assembly from the vehicle.
SEE
FIGURES 11-12
FIGURE 9 - STEP 7
FIGURE 10 - STEP 7
FIGURE 11 - STEP 8
FIGURE 6 - STEP 4
