20.
Connect the bottom of the sway bar end link onto the sway
bar using the supplied 12mm-1.5 x 75 bolts, ½” large flat
washers and nylock nuts. Install the brake line extension
tab using the original bolt and the supplied 5/16” hardware.
SEE PHOTOS BELOW AN IN NEXT COLUMN.
21.
Reinstall the rear tires and torque the lugs to factory
specifications. The factory torque specifications can be
found in your owner’s manual.
22.
Remove the jack stands and set the truck back onto the
ground. Torque the Upper and Lower Link arm bolts to
100 ft. lbs. Check the torque on all the rest of the fasteners.
23.
Check front-end alignment and set to factory specifications.
Sand / grind
down the edge
of the trac bar
for proper
clearance of the
trac bar to the
trac bar bracket
½” Large USS
Flat Washers
One on each
side of bushing
RETORQUE ALL NUTS, BOLTS AND LUGS AFTER 50 MILES AND PERIODICALLY THEREAFTER
.
For technical assistance call: 909-597-7800
