Page
9
with
23
Page
9
with
23
Page
9
with
23
Page
9
with
23
MANUAL - KRAMER Technik MIG / MMA 185
B. COIL ASSEMBLY WITH welding wire
B. COIL ASSEMBLY WITH welding wire
Before mounting a spool of welding wire, please refer to the data contained in the table below:
The diameter of the
welding wire
The maximum size of a spool of wire
welding
0.6 - 0.8 mm
≤D100 - 1kg
•
Raise the housing cover side welding machine.
•
Make sure that the rollers mounted in the drive unit correspond to the type and diameter of the wire used.
•
Place the spool of welding wire spool mounting mechanism, paying attention to the direction of unwinding the
wire was in line with the direction of the entrance to the wire drive unit Lock reels from slipping by tightening
the nut on the body mounting a reel.
•
End of the wire should be flat or cut off the bent section.
•
In order to introduce the wire into the feeder release the pressure feed rollers.
•
End of the wire inserted into the guide at the back of the tray and carry it over the driving roller introducing
nozzle of the welding gun.
•
Push the wire in the groove drive roll and tighten.
•
Remove the gas burner nozzles, and unscrew the contact tip.
•
Switch on the device.
•
Open wire welding torch so that it is simple. ATTENTION! Do not direct the tip of the welding torch in the
direction of the face or other people.
•
If the gas is connected to - close the gas valve. Press the button in the handle MIG / MAG, which will result in the
development of welding wire in the holder.
•
When the end of the welding wire passes through a connector in the burner, a distance of approx. 5 cm and
release the torch.
•
Screw the tip and replace the current gas burner nozzles.
•
Adjust the contact pressure roller by rotating the knob to the right - increase the biasing force to the left - decrease the
pressing force. Too little downforce, will cause slippage of the drive roller. Too high pressure causes an increase in
resistance of administration and the deformation of the wire.
