PAGE 8
CONTROLS AND FUNCTIONS
SEE FIGURES (1-5) ON PAGE 7
SEE FIGURE 1
1. MAIN POWER SWITCH:
TURNS THE MACHINE ON AND OFF.
2. SPEED CONTROL KNOB:
CONTROLS THE DRIVE SPEED ON THE MACHINE
3. REVERSE SWITCH:
DEPRESS DOWN TO DRIVE IN REVERSE. REVERSE IS SET AT 50% SPEED FOR SAFETY.
4. LCD SCREEN:
LISTS FUNCTIONS AND SETTINGS OF THE MACHINE.
5. MENU CONTROL:
SCROLLS THROUGH DIFFERENT OPTIONS ON THE LCD DISPLAY.
6. BRUSH PRESSURE SELECTOR:
CONTROLS THE PRESSURE PUT ON THE SCRUB DECK
.
7. SCRUB DECK SWITCH:
RAISES AND LOWERS THE SCRUB DECK.
8. SOLUTION CONTROL KNOB:
CONTROLS THE SOLUTION FLOW RATE, WHEN SOLUTION SWITCH IS ON
.
9. HANDLE BAR:
USE BOTH HANDS WHEN OPERATING MACHINE.
10. DRIVE CONTROL BUTTONS:
DEPRESS TO DRIVE FORWARD, AND RELEASE TO STOP.
SEE FIGURE 2
11. SOLUTION FILL SCREEN:
PREVENTS DEBRIS FROM GETTING INTO SOLUTION TANK WHILE FILLING.
12. SOLUTION FILL LID:
USED TO REFILL THE SOLUTION TANK WITH CLEANING SOLUTION.
SEE FIGURE 3
13. SQUEEGEE LIFT LEVER:
ROTATE TO LEFT TO RAISE SQUEEGEE, AND TO THE LEFT TO LOWER SQUEEGEE.
14. RECOVERY TANK DRAIN HOSE:
USED TO DRAIN DIRTY RECOVERY WATER FROM TANK, ALWAYS FLUSH OUT COMPLETLY.
15. CHARGER PORT:
RED 50 USED TO RECEIVE CHARGER INPUT.
NOTE:
ONLY USE CHARGER PROVIDED.
16. SQUEEGEE PROTECTION WHEELS:
HELPS PREVENT DAMAGE TO SQUEEGEE WHEN CLEANING CLOSE TO WALLS.
17. SQUEEGEE:
RECOVERS DIRTY WATER FROM FLOOR. KEEP CLEAN AND REPLACE BLADES WHEN WORN
18. SQUEEGEE TRAILING WHEELS:
QUIDES SQUEEGEE AND PREVENTS SWAING.
19. VACUUM HOSE:
VACUUMIZES SQUEEGEE.
NOTE:
KEEP FREE AND CLEAR OF BLOCKAGE.
20. SOLUTION DRAIN HOSE:
USED TO DRAIN SOLUTION TANK.
21. SOLUTION LEVEL INDICATOR TUBE:
SHOWS OPERATOR THE PRECISE LEVEL OF CLEANING SOLUTION IN TANK.
SEE FIGURE 4
22. VACUUM COVER:
PERMITS OPERATOR TO SEE FOAM, AND STOP BEFORE DAMAGE IS DONE TO VACUUM MOTOR .
23. FLUSH OUT TANK LID:
PERMITS ACCESS TO FLUSH OUT RECOVERY TANK AFTER DRAINING.
24. RECOVERY TANK:
HOLDS 30 GALLONS OF DIRTY RECOVERY WATER. MAX TEMP IS 140 F OR 60 C
25. BUMBER ROLLERS:
HELP PROTECT THE MACHINE WHEN CLEANING CLOSE TO OBJECTS.
SEE FIGURE 5
26. CUP HOLDER:
THE MACHINE IS EQUIPED WITH TWO CUP HOLDERS.
27. JAWS:
PROTECT THE SCRUB DECK FROM BEING DAMAGED AND CONTROL SPLASHING. OPEN TO CHANGE BRUSHES.
28. DRIVE WHEELS:
PROVIDE PROPULTION FOR MACHINE.
29. REAR CASTERS:
TWIN CASTERS FOR STABILITY.
Summary of Contents for 28
Page 25: ...BLANK ...
