PAGE 10
6. WHEN BOTH BRUSHES ARE ENGAGED REPLACE
THE BRUSH ACCESS DOOR AND TIGHTEN IT BACK
DOWN WITH THE WINGNUTS.
(SEE FIGURE 14.)
***
FOR CORRECT PAD APPLICATION , CALL YOUR LOCAL DEALER
***
ATTACHING
CYLINDRICAL BRUSHES
1. TURN ON MACHINE POWER
2. RAISE THE SCRUB DECK BY DEPRESSING THE
BRUSH SWITCH TO THE UP AND OFF POSITION
AND TURN MACHINE POWER BACK OFF.
3. UNSCREW THE THREE WINGNUTS ON THE BRUSH
ACCESS DOOR AND REMOVE THE DOOR.
(SEE FIGURE 12.)
ATTACHING
DISK BRUSHES
1. TURN ON MACHINE POWER
2. RAISE THE SCRUB DECK BY DEPRESSING THE
BRUSH SWITCH TO THE UP AND OFF POSITION
AND TURN MACHINE POWER BACK OFF.
3. FOR MACHINES WITH SHROUDS UNSCREW THE TWO
WINGNUTS ON EITHER SIDE OF THE SCRUB HEAD
AND SWING THE SHROUDS
(SEE FIGURE 9.)
4. WITH BRUSHES LOCKED IN PLACE CLOSE SHROUDS
AND TIGHTEN THE WINGNUTS ON ETHER SIDE, OR IF
YOU HAVE JAWS CLOSE JAWS AND PUT PIN BACK IN.
5. SLIDE THE BRUSHES IN ONE AT A TIME. WHEN YOU
GET THE BRUSH ON THE DRIVER SPIN IT WITH YOUR
HAND UNTIL YOU FEEL IT ENGAGE AND DROP IN.
(SEE FIGURE 13.
)
FIGURE 10.
4. FOR MACHINES EQUIPED WITH JAWS, PULL OUT
2 INCH RING PIN IN FRONT OF MACHINE AND
SWING BOTH JAWS.
(SEE FIGURE 10.)
FIGURE 10.
FIGURE 9.
4. SELECT THE CORRECT PADS OR BRUSHES THAT
BEST MEET YOUR CLEANING APPLICATION.
CONSULT YOUR LOCAL DEALER FOR ASSISTANCE.
5.
PAD INSTALATION
ATTACH PADS TO PAD
DRIVERS BEFOR CONNECTING DRIVERS TO
MOTOR HUB.
6. ATTACH BRUSHES OR PADS TO MOTOR HUBS.
SQUEEZE THE SCISSOR LOCKING DEVICE AND LIFT
BRUSH UP ON TO THE MOTOR DRIVE HUB. MAKE
SURE THE SCISSORS CLOSE AND LOCK ONCE THE
BRUSHES ARE ON.
(SEE FIGURE 11.)
FIGURE 11.
FIGURE 12.
FIGURE 13.
FIGURE 14.
Summary of Contents for 28
Page 25: ...BLANK ...
