PAGE 10
Unscrew the three wingnuts on the brush
access door and remove the door. Be
careful not to lose the wingnuts and lock
washers.
(See Fig. 7)
Slide the brushes in, one at a time. When
you get the brush on the driver, spin it with
your hand until you feel it catch and drop
in. When both brushes are in, replace the
door and the fasteners.
(See Fig. 8
)
INSTALLING CYLINDRICAL BRUSH
WARNING:
TURN OFF MACHINE BEFORE INSTALLING BRUSHES.
1.
2.
NOTE: IF BRUSHES ARE NOT FULLY
ENGAGED WITH THE DRIVERS. THE
BRUSHES WILL BE DAMAGED. DO
NOT FORCE THE ACCESS DOOR
BACK ON. THIS USUALLY INDICATES
IMPROPER INSTALLATION.
INSTALLING DISK BRUSH OR PAD
Raise scrub head. Turn the machine on
and press the bottom half of the brush
up/down on/off switch (o).
Pull pin on channel & open brush guards
to access the drivers.
(See Fig. 4)
Select the correct pads or brushes that
best meet your cleaning application.
Consult your local dealer for assistance.
(See Fig. 5 on page 12)
PAD INSTALLATION Attach pads to pad
drivers before connecting drivers to motor
hub. Remove the centerlock ring from the
pad driver and position the pad on the pad
driver, and replace the center locking ring.
Attach brushes or pads to motor hubs.
Squeeze the scissor locking device and lift
brush up on to the motor drive hub. Make
sure the scissors close and lock once the
brushes are on.
(See Fig. 6)
Close the brush shrouds and tighten the
wingnuts on either side.
1.
2.
3.
4.
5.
6.
Fig. 6
Fig. 4
Fig. 7
Fig. 8
