PAGE 16
ONE PASS SCRUBBING
STEPS: (SEE FIGURE 46.)
1. TURN MACHINE ON WITH THE KEY SWITCH.
2. LOWER SQUEEGEE BY PRESSING THE SWITCH.
3. LOWER SCRUB HEAD TO THE FLOOR, USE THE
TOP HALF OF THE BRUSH SWITCH.
4. ADJUST THE SOLUTION LEVER TO THE DESIRED
SETTING. (SET HALF WAY), TURN CLOCKWISE
FOR LESS, COUNTER-CLOCKWISE FOR MORE.
5. BEGIN SCRUBBING BY DEPRESSING THE
FOOT PEDAL SLOWLY AND THEN TO THE SPEED
REQUIRED. (NOT SHOWN)
6. START SCRUBBING AT THE #1 OR # 2 MARKS,
DO NOT USE THE #4 OR #5 MARKS WITHOUT
MANAGEMENTS APPROVAL.
7. TO OPERATE MACHINE IN REVERSE,
SIMPLY SWITCH THE REVERSE SWITCH TO
THE REVERSE POSITION, BACK UP ALARM
MAY SOUND AND YOUR REVERSE SPEED
IS SET TO ROUGHLY 70% OF FORWARD.
8. TO STOP THE MACHINE, LET OFF OF THE
FOOT PEDAL, AND THE MACHINE WILL
STOP AUTOMATICALLY.
(NOT SHOWN)
9. DEPRESSING THE
"Uni-Touch"
BUTTON ACTIVATES
THE SQUEEGEE, VACUUM, AND BRUSHES
SIMULTANEOUSLY.
(GREEN LIGHT WILL ILLUMINATE)
OPERATION
PRE-CLEANING CHECK LIST
READ AND UNDERSTAND THE SAFETY SECTION ON
PAGE 5 AND 6 BEFORE OPERATING MACHINE.
1. CHECK BATTERY CONDITION GAUGE ON
THE CENTRAL COMMAND II LCD SCREEN.
TO CHECK GAUGE PUSH MENU CONTROL
BUTTON UNTIL BATTERY GAUGE APPEARS.
MAKE SURE BATTERIES ARE FULLY CHARGED
BEFOR USING.
2. CHECK THE CONDITION OF PADS OR BRUSHES.
3. CHECK THE CONDITION OF THE SQUEEGEE BLADES.
4. TRANSPORT THE MACHINE TO THE FILLING
STATION. RAISE THE SCRUBHEAD AND
SQUEEGEE WHEN TRANSPORTING.
5. TURN MACHINE OFF.
6. OPEN SOLUTION FILL DOOR AT THE BACK OF
THE MACHINE AND FILL THE TANK UP WITH
CLEAN WATER. FOAM IN THE RECOVERY TANK
IS USUALLY AN INDICATION OF EXCESSIVE SOAP.
(SEE FIGURE 45.)
7. ADD CLEANING CHEMICAL. USE THE PROPER
DILUTION RATIO INDICATED ON THE BOTTLE.
NOTE:
USE ONLY NONFLAMMABLE COMMERCIAL
CLEANING CHEMICALS. YOUR AUTHORIZED
DISTRIBUTOR CAN ASSIST YOU IN SELECTING A
PROPER CHEMICAL.
FIGURE 45.
FIGURE 46.
1
2
3
6
7
4
9