PILOT-OP-EN
- 13 -
LEVELING DISK DECKS:
NOTICE
All Scrubdeck’s should be level at time of machine
delivery. If machine Scrubdeck is not level - Contact your
Servicing Dealer.
1. Drive machine to a fl at level surface and turn machine
OFF
( ).
2. Ensure that Scrubdeck is in full upright position.
Remove Shrouds
(A)
by loosening Star Knobs
(B)
and
pulling away from Scrubdeck
(SEE BELOW)
.
3. Turn
ON
( ) machine and depress the Brush switch.
Just before the Scrubdeck’s drive hubs touch the
ground, turn machine
OFF
( ). Remove key.
4. Loosen the Locking Nut
(C)
on the Adjustable Deck
Arms. Turn the Hexagonal Arm
(D)
on each side of the
Scrubdeck to level it
(SEE BELOW)
.
5. Extending the Adjustable Arms raise the front and
lowers the rear of the Scrubdeck. After Scrubdeck has
been leveled
(ensure correct pitch backward - if you
have)
- retighten Locking Nuts
(C)
.
ADJUST DISK SHROUD WIPERS:
1. For Shroud rubber adjustments, loosen the Nylok Nuts
(E)
on the back of the Shrouds
(SEE BELOW)
.
2. To adjust rubber to the desired height, just slide the
curtain up or down in the slits and tighten screws.
3. Reattach the Shroud to the Scrubdeck by sliding back
on and tightening the Star Knobs.
ADJUST DISK SHROUDS:
1. For Shroud adjustments, loosen the Start Knobs
(F)
and remove Shroud
(SEE BELOW)
.
2. Spin the Red Shroud Adjustment Knobs
(G)
up or
down on the Shroud Support Bolt
(SEE BELOW)
.
3. Once adjusted to the proper height, tighten shrouds
back in place.
C
D
B
A
B
E
F
D
