- 14 -
PILOT-OP-EN
INSTALLING CYLINDRICAL BRUSH:
1. Turn
ON
( ) machine power.
2. Raise the Scrubdeck by depressing the Brush switch
to the up and
OFF
( ) position
(Or Raise with Lever
- OPTIONAL)
and turn the machine power back
OFF
(
). Remove Key.
CAUTION
Disconnect the batteries.
3. Remove Side Wiper pin
(A)
and open the Wipers out-
ward to allow access to the Cylindrical Door
(B)
(SEE
BELOW)
.
4. Press Side Door Latch
(C)
and pull door off of Scrub-
deck to allow access to the brushes
(SEE BELOW)
.
5. Slide
Brush
(D)
into Brush area and engage onto the
Brush Driver on the opposite side
(SEE BELOW)
.
6. With Brushes engaged, re-attach the Side Door as
well as the Side Wipers.
NOTICE
If the Brushes are not fully engaged with the Drivers,
the Brushes will be damaged. Do
NOT
force the access
door back on. This usually indicates improper Brush
installation.
7. Brush drivers shown misaligned
(SEE BELOW)
.
8. Brush driver shown properly aligned
(SEE BELOW)
.
A
D
NEW STYLE DRIVER
NEW STYLE DRIVER
B
C
