PILOT-OP-EN
- 15 -
LEVELING CYLINDRICAL DECKS:
NOTICE
All Scrubdeck’s should be level at time of machine
delivery. If machine Scrubdeck is not level - Contact your
Servicing Dealer.
1. Drive machine to a fl at level surface and turn machine
OFF
( ).
2. Ensure that Scrubdeck is in full upright position and
remove brushes.
3. Turn
ON
( ) machine and depress the Brush switch.
Just before the Scrubdeck touches the ground, turn
machine
OFF
( ).
4. Loosen the Locking Nut
(A)
on the Adjustable Deck
Arms. Turn the Hexagonal Arm
(B)
on each side of the
Scrubdeck to level it. Use the levels built into the deck
(SEE BELOW)
.
5. Extending the Adjustable Arms raise the front and
lowers the rear of the Scrubdeck. After Scrubdeck has
been leveled - retighten Locking Nuts
(A)
.
ADJUST CYLINDRICAL WIPERS BLADES:
1. For Cylindrical side Wipers, open wipers by releasing
the pin. Loosen Wiper band screws
(B)
(SEE
BELOW)
.
2. To adjust Wiper to the desired height, just slide the
Wiper up or down in the slots and tighten the screws.
A
B
FRONT:
BACK:
B
