- 16 -
PILOT-OP-EN
INSTALLING ORBITZ PADS:
1. Turn
ON
( ) machine power.
2. Raise the Scrubdeck by depressing the Brush switch
to the UP and
OFF
( ) position and turn machine
power back
OFF
( ). Remove Key.
3. Select the correct Pads that best meet your cleaning
application. Consult your local dealer for assistance.
4. Remove the ORBITZ Scrubdeck Shrouds
(E)
by turn-
ing the Rubber Star knobs
(F)
and sliding the shroud
off
(SEE BELOW)
.
5. Remove any Pad previously attached to the ORBITZ
Grip Face by pulling down from the corners
(SEE
BELOW)
.
6. Once Grip Face is clear of any Pads, place pad want-
ed for application centered on the Grip Face
(This will
leave a
½
’’ overhang on all sides)
.
7. Press upwards on the Pad to secure it in place
(SEE
ABOVE)
.
8. With Pad attached securely to Grip Face of ORBITZ
Deck, the machine is ready to use.
NOTICE
NEVER place aggressive Pads (Maroon Prep, Dominator
HD Strip, etc.) directly onto the Grip Face. Always use
Red or Blue Spacer pad to prevent Grip Face damage.
LEVELING ORBITZ DECKS:
NOTICE
All Scrubdeck’s should be level at time of machine
delivery. If machine Scrubdeck is not level - Contact your
Servicing Dealer.
1. Drive machine to a fl at level surface and turn machine
OFF
( ).
2. Ensure that Scrubdeck is in full upright position.
3. Turn
ON
( ) machine and depress the brush switch.
Just before the Scrubdeck’s ORBITZ Pad touches the
ground, turn machine
OFF
( ). Remove key.
4. Loosen the Locking Nut
(A)
on the Adjustable Deck
Arms. Turn the Hexagonal Arm
(B)
on each side of the
Scrubdeck to level it. Use the Scrubdeck Levels
(C)
built into the deck
(SEE BELOW)
.
5. Extending the Adjustable Arms raise the front and
lowers the rear of the Scrubdeck. After Scrubdeck has
been leveled - tighten Locking Nuts
(A)
.
A
A
C
B
F
F
E
