PILOT-OP-EN
- 23 -
BATTERY CHARGING
Charger Specifi cations
•
Output voltage of 36 Volts
•
Output current of 25 amps max
(Optional)
•
Input voltage of 110 Volts/ 60 Hz
(220V/50 Hz available)
•
Automatic shut off circuit
•
Made for Deep Cycle Batteries
DANGER
Explosive hydrogen gas forms when Batteries are
charging. An open fl ame or spark can cause this gas
to explode. Serious personal injury or property damage
could occur. Only charge the Batteries in this machine
in a well ventilated area.
WARNING
Before you service a Battery, always wear face protec-
tion, protective gloves and protective clothing. Battery
acid or battery explosion can cause serious injuries.
WARNING
The Batteries in this machine contain sulfuric acid,
which causes burns to skin. If battery acid contacts
clothing or skin, rinse the effected area with cold water
immediately. If battery acid gets on your face or in your
eyes, fl ush the area immediately with cold water and
seek medical attention.
CAUTION
Always use the automatic battery charger provided by
the manufacturer of this machine to charge the Batter-
ies of this machine. It is designed to charge the Batter-
ies at the appropriate rate. If you must use a different
charger, disconnect the Batteries before charging to
avoid damage to the electronic speed controller.
EXTERNAL BATTERY CHARGING:
1.
Transport machine to a well ventilated area for charging.
2.
Turn the machine
OFF
( ). Remove key. Tip Seat
(A)
to
side for Battery Access
(SEE BELOW)
.
3.
Check the water in each Battery
(B)
(SEE BELOW)
. Do
not charge the machine unless the water is slightly higher
than the plates. If needed, add enough distilled water to just
slightly cover the plates. Be careful not to over fi ll. Batteries
can overfl ow during charging. Replace caps before charging.
4.
First, plug the (grey 50) Charger plug into the machine’s
Charger Port
(C)
(SEE BELOW)
. After the Charger plug is
connected, plug the charger power cord into a grounded 110
Volt / 60 hz standard wall outlet
(D)
(SEE BELOW)
. Ensure
to leave the seat lid open while charging.
5.
The Charger will begin charging and shut off when fully
charged
(check Charger Amp gauge)
.
6.
After the Charger has turned off - First, unplug the Charger
from the wall outlet. Second, unplug the grey 50 Charger
plug from the machine.
7.
Recheck the cell level after charging. If needed, add distilled
water up to the correct level. Be certain to replace the caps
securely and to wipe off the top of the Batteries with a clean
cloth.
WATER LEVEL SHOULD BE
1/8'' ABOVE PLATES
B
C
C
D
A
