PILOT-OP-EN
- 7 -
OPERATION CONTROLS
1.
BATTERY GAUGE / HOUR METER:
Indicates the amount of battery charge remaining along with total hours
used - Below 20% and machine goes into “creep” mode to save charge to allow machine to be driven back to
charging station
2.
BRUSH MOTOR AMP GAUGE:
Indicates amp draw of the Scrubdeck motors combined
3.
VACUUM SWITCH [WHITE]:
Turns the Vacuum Motor
ON
( )
/
OFF
( )
4.
SOLUTION FLOW SWITCH [BLUE]:
Turns solution fl ow
ON
( )
/
OFF
( )
5.
SCRUBDECK SWITCH [BLACK]:
Raises and lowers the Scrubdeck - Scrubdeck turns on automatically when
lowered and foot pedal is pressed
6.
KEY SWITCH:
Turns power of the machine
ON
( )
/
OFF
( )
7.
REVERSE SWITCH [RED]:
Switch to forward position to drive forward - back position for reverse (Alarm will
sound in reverse)
8.
SOLUTION FLOW CONTROL LEVER:
Adjusts the amount of solution fl ow delivered to the Scrubdeck ( + / - )
9.
CIRCUIT BREAKER:
15 amp Positive Bus Bar ( + )
10.
CIRCUIT BREAKER:
15 amp Negative Bus Bar ( - )
11.
CIRCUIT BREAKER:
25 amp Vacuum Motor
12.
CIRCUIT BREAKER:
30 amp Scrubdeck Motor
13.
CHARGER PORT:
Plug in grey charger connector here to charge machine batteries (OEM 36 Volt / 25 Amp Only)
14.
QR CODE:
Scan machine serial QR Code and see all of the machines BornOn Information
15.
RECHARGE METER:
Indicates amount of times machine has been connected to a charger
16.
POWER ON METER:
Hour meter to indicate complete time key has been
ON
( )
17.
DRIVE MOTOR METER (OPTIONAL):
Indicates complete time Drive Motor has been in use
18.
SCRUBDECK MOTOR METER (OPTIONAL):
Indicates complete time Scrub Motor(s) has been in use
19.
VACUUM MOTOR METER (OPTIONAL):
Indicates complete time Vacuum Motor has been in use
6
7
1
2
3
4
5
8
10
11
12
13
17
14
18
15
19
16
9
