Via Mantova, 177/A - 37053 Cerea (Verona) Italy - Tel. +39 0442 330422 r.a. - Fax +39 0442 331054 - e-mail: info@fadini.net - www.fadini.net
AUTOMATIC GATE MANUFACTURERS
®
s.n.c.
EUROPEAN MARK CERTIFYING CONFORMITY TO
THE ESSENTIAL REQUIREMENTS OF THE
STANDARDS 98/37/EC
• DECLARATION OF CONFORMITY
• SAFETY NORMS
• EN 12453, EN 12445 STANDARDS
• CEI EN 60204-1 STANDARDS
• WARRANTY CERTIFICATE ON THE CUSTOMER’S REQUEST
WARNINGS
- Perform a
Risk Analysis
before every installation and resolve risks through the use of safety devices in compliance with
EN 12445 and EN 12453 safety standards
- Follow the instructions provided
- Dispose of all cardboard, nylon, polystyrene and other packaging with specialized waste disposal firms
- If removing the actuator,
do not cut
the electric wires, but disconnect them from the terminal box by loosening the screws inside
the junction box
- Disconnect the mains switch before opening the electrical wire junction box cover
- The whole automation should be earthed with the yellow/green wire
We recommend reading the “Safety Norms”, suggestions and observations in this booklet very carefully.
FIBO 300 COMPONENTS
FIBO 300 INSIDE PROTECTION CABINET WITH
CUSTOMIZED KEY
“E.P.P.”
UPON REQUEST: ELECTRIC POWER PANEL
WITH ELPRO 10 PLUS PROGRAMMER
AND ACCESS KEYS
630
400
384
70
gear
425
315
165
“F”
LIMIT SWITCH STRIKE PLATES
30
130
“M”
27 mm RELEASE BOX SPANNER
155
INSPECTIONS AND MAINTENANCE
In order to ensure optimal system performance over time and so as to comply with current safety standards, it is necessary to follow
the correct maintenance and monitoring procedures for the entire automation, electronic devices and wiring:
- Oil-hydraulic automation: maintenance inspection around every 6 months
- Electronic devices and safety systems: maintenance inspection monthly.
Made in Italy
®
The manufacturers reserve the right to change the products without any previous notice
Distributor’s box
10-2005
Summary of Contents for FIBO 300
Page 1: ...G B INSTALLATION MANUAL...
