VIGILO
VIGILO
10
Post cover
Rubber buffer
Cover plate
Retractable
post
230 V
230 V
=
=
NO
22 23
GREASE
IMPORTANT:
WE RECOMMEND
GREASING ALL CLAMPING
SCREWS
1
2
3
4
5
6
7
8
9
10
11
12
1
2
3
4
5
6
7
8
9
10
11
12
1
4
2
3
5
English
fully retractable oil-hydraulic bollard
VERSION OF CORAL WITH SOLENOID VALVE
In the version of
VIGILO with solenoid valve
no manual overriding action is needed, and in case of power failure the post descends
automatically flush with pavement level. To enable the solenoid valve to operate properly, the electric wires labelled
“ELETTROVALVOLA - Solenoid valve” from the post assembly are to be connected, through the
voltage stabilizer
, to terminals 22
and 23 in the Elpro S40 control box.
Pic. 12
VIGILO with solenoid valve
VIGILO with solenoid valve
VIGILO with solenoid valve
SOLENOID VALVE
STABILIZER
GROUND-LEVEL CLOSURE - COVER PLATE
• Use the four screws to close the cover plate.
• Lift the retractable post for facilitate closure of the post cover
with the buffer, give the command (by encoding a transmitter
with the radio receiver or a key switch) to lift the retractable
post.
Pic. 13
MANUAL RELEASE OPERATIONS
In the case of a blackout, the post can be lowered manually following the instructions show in pic. 14.
Insert the release key
in the release key recess
Release the hydraulic circuit
by turning the release key
one turn anti-clockwise
Press to lower the post manually
Pic. 14
Block the hydraulic circuit
by turning the release key
clockwise (tighten until
securely locked)
