ELPRO S40
20 μF
VIGILO
VIGILO
9
A
11 12 13
16 17 18
22 23
52 53
52 53
FINEC
ORSA
BL
U C
OMUNE
Limit swit
c
h
Blue c
ommon
LED
CICALINO
Le
d
Beeper
LED
CICALINO
Le
d
Beeper
B
STABILIZER
!
20 μF
A
NC
230 V
B
16
18
17
16
18
17
English
fully retractable oil-hydraulic bollard
ELECTRICAL CONNECTIONS TO THE CONTROL BOARD
closing limit switch M1
(post up)
opening limit switch M1
(post down)
Standard Vigilo
Standard Vigilo
Vigilo with
LED lights
Vigilo with
LED lights
Vigilo with
solenoid valve
VIGILO bollard
Pic. 10
Vigilo with LED lights
common
S
o
lenoid valv
e
po
w
er supply
LED po
w
er supply
blink
ing ligh
t
LED po
w
er supply
steady ligh
t
blue c
ommon
blue c
ommon
blue c
ommon
blue c
ommon
br
o
w
n
br
o
w
n
black
black
mot
or liv
e
mot
or liv
e
FIRST OPERATION MANOEUVRES
Having terminated installation of the traffic control post and all the safety and control accessories (
all of the NC contacts on the
Elpro S40 board are to be bridged
), and the respective connections with the Elpro S40 programmer, and having completed
thorough risk analysis, the first operation manoeuvres can be performed. If you have a radio transmitter, encode the radio receiver
according to the relative instructions before giving the command to raise the retractable post, or give the manoeuvre command
using a key switch. Once power is supplied, connect the motor/pump cable and, satisfied that the limit switch LEDs are properly
alight, the post should move up on the first commanding pulse; should it fail, disconnect power supply and swap the connections
to the live terminals.
NOTE WELL: supply the system with electric power only after all of the electrical connections have been made as
required for proper operations.
All NC contacts are to be closed
Should the motor fail
to drive the post up by
first pulsing, swap the
connections to the electric
motor live terminals only
common
common
Pic. 11
1
st
pulse
In case of multiple installations go
through the same procedure with each post