10. Other hot beverages
Steam dispensing
Put a cup with the beverage you wish to heat under the right
or left steam nozzle (
6
).
Completely immerse the steam nozzle in the beverage.
Gradually open up the steam ta (
7
) , allow the beverage to heat
to the desired temperature, stop the flow of steam by turning
knob (
7
) the other way (towards “0”).
Note: At the conclusion of each steam dispensing phase, clean
the inside of the steam nozzle as follows:
Turn the nozzle towards the cup tray and carefully
activate steam dispensing at least once.
Heating milk for frothy coffee (cappuccino)
Use a tall narrow jug and fill it up to about the half-way mark.
Then plunge the steam jet pipe (
6
) into the milk.
Gradually open up the steam tap (
7
) and heat the milk for a
few seconds.
When the required amount of froth has been made and the
temperature is sufficiently high, stop the flow of steam by
turning knob (
7
) the other way (towards “0”).
When the steam jet pipe (
6
) is no longer required, clean it
thoroughly with a sponge and a clean cloth.
Distribution hot water
After having positioned the appropriate container under the hot
water nozzle (8), distribution is made in two ways.
Dosed Function
Press the hot water distribution key (
9
) hot water will be issued
and will stop automatically upon completion.
The distribution may be interrupted at any time by pressing the
previously active key again (shown by the lighted led).
Continous Function
Press the hot water distribution key (
9
) and keep pressed for
approximately 3 seconds.
Hot water will be issued continuously until the hot water key
(
9
) is pressed again to stop this function.
In continuous function the progrmmed dosed in the key is
not changed.
8
6
9
7
7
6
27
English
