Declaration
The throttle is not back in its correct
position.
The throttle has fault.
Overvoltage protection
Error with the hall sensor signal inside
the motor
Motor Phase Abnormality
The temperature inside the engine has
reached its maximum protection value
The temperature sensor inside the
motor has an error
Error with the current sensor in the
controller
Error with the temperature sensor inside
of the battery
The protection temperature inside the
controller has reached its maximum
protection value
Error with the temperature sensor inside
the controller
Speed sensor Error
Torque signal Error
Troubleshooting
Check the throttle can adjust back into its
correct position, if the situation does not
improve, please change to a new throttle.
(only with this function)
1. Check the connector of throttle whether
they are correctly connected.
2. Disconnect the throttle, If the problem still
occurs, please contact the Support. (only
with this function)
1. Remove the battery.
2.Re-Insert the battery.
3.If the problem persists, please contact the
Support.
Please contact the Support.
Please contact the Support.
1.Turn off the system and allow the e-bike to
cool down.
2.If the problem persists, please contact the
Support.
Please contact the Support.
Please contact the Support.
Please contact the Support.
1.Turn off the system and let the e-bike cool
down.
2.If the problem persists, please contact the
Support.
Please contact the Support.
1.Restart the system
2.Check that the magnet attached to the
spoke is aligned with the speed sensor and
that the distance is between 10 mm and 20
mm.
3.Check that the speed sensor connector is
connected correctly.
4.If the error persists, please contact the
Support.
1.Check that all connections are connected
correctly.
2.If the error persists, please contact the
Support.
Error
04
05
07
08
09
10
11
12
13
14
15
21
25
20
Summary of Contents for FM9
Page 1: ...Smart EV Moped User Manual Model FM9 EN DE FR IT ES...
Page 2: ......
