38
3. Close the Device manager.
Removing the adapter software
The adapter software can be removed as follows:
1. Click on
Start
, click on
Control panel
and then click on
Software
.
2. Click on
Modify or remove program
then click on
PL-2303-USB-to-Serial
.
3. Click on
Modify/remove
to uninstall the software.
3.3.3 Balancing activation
The Detector III is supplied ex works with the balancing functionality switched off.
You can enable this function if you have purchased a Detector III balancing kit.
The balancing kit contains a USB dongle which can be used to enable one unit
only.
Dongle
This activation is essentially carried out as follows:
·
A dongle is supplied with the balancing kit that has not previously been used.
·
You can use this dongle to enable the balancing functionality for only one
Detector which can be selected at will.
·
Once enabled, the serial number of the Detector is saved on the dongle. From
this point onwards the dongle may only be used with this specific Detector.
·
You can also deactivate the balancing functionality in the Detector once again
